WATER LEAK AT FRONT FLOOR ’02 –’06 Toyota Camry (TMMK), ’04 –’06 Toyota...
download Some customers may experience a water leak at the front floor area. Water may be Introduction entering the body due to a body sealer void on the engine compartment rear wall, near the upper...
View Article1999 Daewoo Nubira SX TIMING BELT REMOVAL & INSTALLATION
download Removal 1. Disconnect negative battery cable. Disconnect intake air temperature sensor connector from intake air duct. Disconnect the air intake tube from the throttle body. Disconnect the...
View ArticleENGINE MISFIRE 2003-2004 Mustang, 1999-2004 Navigator 2002-2003 Blackwood...
download Some 1999-2004 Navigator, 2002-2003 Blackwood, 2003-2005 Aviator, 2003-2004 Marauder and 2003-2004 Mustang vehicles built before 12/19/2004 equipped with 4.6L 4V/5.4 4V engine may exhibit a...
View Article1994 Ford Aerostar/Ranger/Explorer Camshaft Timing ADJUSTMENTS
download Checking Timing An access plug is provided in the cam drive belt cover so that camshaft timing can be checked without removal of the cover or any other parts. 1. Remove the access plug from...
View Article1996 Mitsubishi Eclipse GS-T TIMING BELT & BALANCE SHAFT BELT Removal
download 1. Disconnect negative battery cable. Remove engine undercover. Place wooden block between jack and oil pan, and raise engine slightly. Remove engine mount assembly near timing belt cover. 2....
View Article1998 – 1999 Toyota Camry & Toyota Solara inoperative Vapor Pressure Sensor 3...
download Introduction Under certain driving conditions, some 1998 – 1999 model year Camry and Solara vehicles may exhibit a M.I.L. “ON” with DTCs P0440, P0441 and P0446 stored due to an inoperative...
View Article2003 TOYOTA TACOMA TIMING BELT INSTALLATION REMOVAL
download NOTICE: Always turn the crankshaft clockwise. (c) Check that the timing marks of the camshaft timing pul- leys and No.3 timing belt cover are aligned. If not, turn the crankshaft pulley 1...
View Article1997 Ford F-150/250 Timing Chains Removal
download 1. Remove the engine front cover; refer to the procedure in this section. 2. Remove the (A) crankshaft sensor ring from the (B)crankshaft (6303). 3. On WEP engines, use the (A) Camshaft...
View Article1994 Toyota Camry DX TOYOTA’’2.2L 4-Cylinder – Gasoline TIMING BELT REMOVAL &...
download 1. Disconnect negative battery cable. Raise and support vehicle. Remove lower engine cover. On Celica and Camry, remove right front wheel. On all models, lower vehicle. 2. On MR2, remove right...
View Article1999 Pontiac Grand AM Revised Timing Chain, Sprocket, and Tensioner Replacement
download Note: GM does not provide timing chain timing marks, or information to perform timing chain service without the special tools shown in this procedure. Tools Required: – - J 36800 Camshaft...
View Article
